Onkyo TX-NR1007 instruction manual Through, Auto, 480p 480p/576p, 720p, 1080i, 1080p, Source

First Time Setup—Continued

5 Use the Up and Down [q]/[w] but- tons to select “Resolution”, and use the Left and Right [e]/[r] buttons to select:

Through:

Select this to pass video through the AV receiver at the same resolution and with no conversion.

Auto* :

Select this to have the AV receiver automatically convert video at reso- lutions not supported by your TV.

480p (480p/576p):

Select this for 480p or 576p output and video conversion as necessary.

720p:

Select this for 720p output and video conversion as necessary.

1080i:

Select this for 1080i output and video conversion as necessary.

1080p* :

Select this for 1080p output and video conversion as necessary.

Source:

Output will be according to the res- olution level which was set in the “Picture Adjust” setting (see page 100).

Tips:

• The “Resolution” setting can also be set using the [VIDEO] button on the remote controller.

• The “Resolution” setting is set respectively of main, sub, and analog.

Notes:

• Settings marked with an asterisk (* ) are not available when the “Monitor Out” setting is set to “Analog”.

• If the “Monitor Out” setting is set to “Both”, this setting is fixed at “Auto”.

6	Press the [SETUP] button.
	The setup menu closes.

Notes:

•See page 27 for charts showing how the “Monitor Out” and “Resolution” settings affect the video signal flow through the AV receiver.

•This procedure can also be performed on the AV receiver by using its [SETUP] button, arrow buttons, and [ENTER] button.

48