Onkyo TX-NR1007 instruction manual 130, Adjusting the Volume for Zones, Muting Zones

Multi Zone—Continued

Notes:

•Only analog input sources are output by the ZONE 2/ 3 PRE OUT and ZONE 2/3 L/R speaker terminals. Digital input sources are not output. If no sound is heard when an input source is selected, check if it’s connected to an analog input.

•You cannot select different AM or FM radio stations for your main room and Zone 2/3. The same AM/FM radio station will be heard in each room. For example, if you have an FM station for the main room, that sta- tion will also be used in Zone 2.

•When you connect Zone 2 speakers directly to the AV receiver, listening modes that require front high or front wide speakers such as Dolby Pro Logic IIz Height or Audyssey Dynamic Surround Expansion™ are unavailable.

•When you connect Zone 3 speakers directly to the AV receiver, listening modes that require surround back speakers such as Dolby EX, DTS-ES or THX Ultra2 Cinema are unavailable.

•When the input selector of Zone 2/3 is selected, power consumption on standby mode slightly increases.

•While Zone 2/3 is on, ufunctions will not work.

Adjusting the Volume for Zones

Remote	On the remote controller, press
controller	the [ZONE] button repeatedly,
	and then use the VOL [q]/[w]
	button.

AV receiver On the AV receiver, press the

[ZONE 2] or [ZONE 3] button (the

ZONE 2/3 indicator and Zone 2/3

selector on the display flashes) and press [LEVEL] button followed by the [e]/[r] buttons within 8 seconds.

Muting Zones

Remote	On the remote controller, press
controller	the [ZONE] button repeatedly,
	and then press the [MUTING]
	button.
	To unmute a zone, on the remote
	controller, press the [ZONE]
	button, and then press the
	[MUTING] button again.

Adjusting the Tone and Balance of Zones

1	On the AV receiver, press the
	[ZONE 2] or [ZONE 3] button.
	AV receiver

2	Press the AV receiver’s [TONE]
	button repeatedly to select
	“Bass”, “Treble” or “Balance”.
3	Use the Up [r] and Down [e]

buttons to adjust the bass, treble or balance.

• You can boost or cut the bass or tre- ble from –10 dB to +10 dB in 2 dB steps.

•You can adjust the balance from 0 in the center to +10 dB to the right or +10 dB to the left in 2 dB steps.

Notes:

•Zones can also be unmuted by adjusting the volume.

•The volume, tone and balance functions cannot be set when the “Zone2 Out” or “Zone3 Out” setting is set to “Fixed” (page 128) and “Powered Zone2” or “Pow- ered Zone3” setting is set to “Not Act” (page 127).

•Even if you repeatedly press the remote controller’s [ZONE] button to select zones, the last zone selection will be retained once you have switched to other com- ponents by pressing other REMOTE MODE buttons after pressing the [ZONE] button.

130