Onkyo TX-NR1007 instruction manual 134, Entering Remote Control Codes

Controlling Other Components—Continued

Entering Remote Control Codes

You’ll need to enter a code for each component that you want to control.

1	Look up the appropriate remote
	control code in the separate
	Remote Control Codes list.
	The codes are organized by category
	(e.g., DVD player, TV, etc.).

DISPLAY

REMOTE

MODE

Number buttons

2

(3 seconds)

While holding down the REMOTE MODE button to which you want to enter a code, press and hold down the [DISPLAY] button (about 3 seconds).

The REMOTE MODE button lights up.

Notes:

•Remote control codes cannot be entered for the [RECEIVER] and [ZONE] buttons.

•Only TV remote control codes can be entered for the [TV] button.

•Except for the [RECEIVER], [TV], and [ZONE] buttons, remote control codes from any category can be entered for the REMOTE MODE buttons. However, these buttons also work as input selector buttons (page 62), so choose a REMOTE MODE button that corresponds with the input to which you connect your component. For example, if you con- nect your CD player to the CD input, choose the [CD] button when enter- ing its remote control code.

3	Within 30 seconds, use the num-
	ber buttons to enter the 5-digit
	remote control code.

The REMOTE MODE button flashes twice.

If the remote control code is not entered successfully, the REMOTE MODE button will flash once slowly.

Note:

The remote control codes provided are correct at the time of printing, but are subject to change.

134