Onkyo TX-NR1007 instruction manual Monitor Out Setup

First Time Setup—Continued

Monitor Out Setup		4	Use the Up and Down [q]/[w] but-
If you connect your TV to the HDMI output, set the			tons to select “Monitor Out”, and
			use the Left and Right [e]/[r]
“Monitor Out” setting so that the onscreen setup menus			buttons to select:
are displayed and composite video, S-Video, and			Analog:
component video sources are upconverted and output.
			Select this if your TV is connected
If you connect your TV to the COMPONENT VIDEO
			to the COMPONENT VIDEO
MONITOR OUT, set the “Monitor Out” setting so that			MONITOR OUT, S MONITOR
the onscreen setup menus are displayed and composite			OUT, or V MONITOR OUT.
video and S-Video sources are upconverted and output.			HDMI Main:
You can specify the output resolution for the HDMI			Select this if your TV is connected
outputs and COMPONENT VIDEO MONITOR OUT			to the HDMI OUT MAIN.
and have the AV receiver upconvert the picture			HDMI Sub:
resolution as necessary to match the resolution			Select this if your TV is connected
supported by your TV.			to the HDMI OUT SUB.
1	Press the [RECEIVER] button,		Both:
			Select this if your TVs are con-
	followed by the [SETUP] button.
			nected to the HDMI OUT MAIN
	The main menu appears onscreen.
			and HDMI OUT SUB. Video sig-
	If the main menu doesn’t appear, make		nals are output from both HDMI
	sure the appropriate external input is		outputs at the resolution supported
	selected on your TV.		by both TVs.
			Both (Main):
			Select this if your TVs are con-
2	Use the Up and Down [q]/[w] but-		nected to the HDMI OUT MAIN
			and HDMI OUT SUB. Video sig-
	tons to select “1. Input/Output		nals are output from both HDMI
	Assign”, and then press		outputs but HDMI OUT MAIN will
	[ENTER].		become a priority; depending on the
	The “Input/Output Assign” menu		resolution, video signals may not be

appears.	output from HDMI OUT SUB.
	Both (Sub):

1. Input/Output Assign

1.Monitor Out

2.HDMI Input

3. Component Video Input

4. Digital Audio Input

5. Analog Audio Input

3	Use the Up and Down [q]/[w] but-
	tons to select “1. Monitor Out”,
	and then press [ENTER].

Select this if your TVs are con- nected to the HDMI OUT MAIN and HDMI OUT SUB. Video sig- nals are output from both HDMI outputs but HDMI OUT SUB will become a priority; depending on the resolution, video signals may not be output from HDMI OUT MAIN.

Notes:

The “Monitor Out” menu appears.

1–1.	Monitor Out
Monitor Out		HDMI Main
Resolution		Through
Brightness		0
Contrast		0
Hue		0
Saturation		0

•If not connected to the same output you have selected in the“Monitor Out” setting, the “Monitor Out” setting will be automatically switched to “Analog”.

•When you select other than “Analog”, the onscreen setup menus are output by only the HDMI outputs. If you’re not using the

HDMI output and select settings by mistake and the menus disappear, press the [MONITOR OUT] button to select “Analog”.

•For Deep Color output, if the “Monitor Out” setting is set to “Both (Main)” or “Both (Sub)”, the number of bit may be limited due to the capability of your TV connected to a priority output.

47