Turning On the AV receiver

(North American models)

(European and Asian models)

 

 

ON/STANDBY

 

ON/STANDBY

STANDBY

 

 

ON

 

 

 

STANDBY indicator

 

 

 

STANDBY indicator

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

RECEIVER

POWER

Turning On and Standby

1

(European and Asian models)

 

 

Set the [POWER] switch to the ON position (

 

 

 

).

The AV receiver enters Standby mode, and the STANDBY indicator comes on.

2

AV receiver

Remote

 

controller

or

On the AV receiver, press the [ON/STANDBY] button.

On the remote controller, press the [RECEIVER] button, followed by the [ON] button.

The AV receiver comes on, the display lights up, and the STANDBY indicator goes off. Pressing the remote controller’s [ON] button again will turn on any components connected via u.

To turn the AV receiver off, press the [ON/STANDBY] button, or press the remote controller’s [STANDBY] button. The AV receiver will enter Standby mode. To prevent any loud surprises when you turn on the AV receiver, always turn down the volume before you turn it off.

European and Asian models: To completely shut down the AV receiver, set the [POWER] switch to the OFF position ().

Smooth Operation in a Few Easy Steps

To ensure smooth operation, here’s a few easy steps to help you configure the AV receiver before you use it for the very first time. These settings only need to be made once.

Did you connect your TV to an HDMI output or COMPONENT VIDEO MONITOR OUT?

If you did, “Monitor Setup” on page 44.

Run MultEQ XT Room Correction and Speaker Setup—this is essential!

See “Audyssey MultEQ® XT Room Correction and Speaker Setup” on page 56.

Have you connected a component to an HDMI input,

HDMI

component video input, or digital audio input?

 

If you have, see “HDMI Input Setup” on page 49, “Component Video Input Setup” on page 50, or “Digital Audio Input Setup” on page 51 respectively.

Have you connected an Onkyo MD recorder, CD recorder,

OUT IN

or RI Dock?

If you have, see “Changing the Input Display” on page 55.

TV/TAPEMD recorder, CD recorder,

RI Dock

43

Page 43
Image 43
Onkyo TX-NR1007 instruction manual Turning On the AV receiver, Turning On and Standby, Smooth Operation in a Few Easy Steps