Functions for specific subjects and purposes

Taking pictures automatically at set intervals [Time Lapse Shot]

●●This function is not intended for application-specific systems (monitoring cameras).

If you leave the camera unattended during [Time Lapse Shot] recording, make sure that the camera is not stolen.

Exercise caution when you perform [Time Lapse Shot] recording for a long period of time in cold regions or in a low-temperature or high-temperature/high-humidity environment, since such use could cause malfunctions.

●●The camera may not be able to record using the preset interval and number of pictures to be recorded under some recording conditions.

●●If the recording time is longer than the preset interval due to a long exposure, this may cause the recording to skip.

●●Use a sufficiently charged battery or an AC adaptor (optional) and DC coupler (optional). ●●[Time Lapse Shot] is paused in the following cases:

••When the remaining battery power runs out

••Turning the camera off

If this occurs during [Time Lapse Shot] recording, you can restart the operation by replacing the battery or card in the pause state and turning the Camera [ON/OFF] switch to [ON]. (Note, however, that the pictures recorded after restarting the operation are saved as another group picture.) When you replace the battery or card, turn the Camera [ON/OFF] switch to [OFF].

●●Do not connect the AV cable (optional), HDMI micro cable or USB connection cable (supplied) during [Time Lapse Shot] recording.

●●When you select the picture quality for an aspect ratio that is different from the original picture, the picture will be displayed with a black band on the upper/lower side or the left/right side of a stop motion animation.

●●If the power supply is cut off due to a power outage or AC adaptor disconnection while a motion picture is being recorded using the AC adaptor (optional), that motion picture will not be recorded.

●●You cannot create a motion picture that is longer than 29 minutes 59 seconds, or whose file exceeds 4 GB.

●●When a stop motion animation is shorter than 2 seconds, “2s” will be displayed for the motion picture recording time (→70).

●●When the number of recorded pictures is one, it will not be saved as a group picture.

Not available in the following cases:

●●[Time Lapse Shot] cannot be used In the following cases:

••During panorama picture recording

••When [Multi Exp.] is set

••When using [Stop Motion Animation]

••When the [Simultaneous record w/o filter] is set to [ON]

155

SQW0021

Page 155
Image 155
Panasonic DMC-LX100 owner manual 155, Not available in the following cases