Panasonic MN1030 Operand error, Illegal operand value, Define symbol multiple defined, Series

Chapter 13 Error Messages

13.2.1 Warning Messages

2001	Operand error
	An operand is of the wrong type.
	Check the number and types of operands,
2002	Illegal operand value
	An operand does not have an acceptable value.
	Change the value of the operand.
2003	Define symbol multiple defined.
	The same symbol is defined twice.
	Change the identifier after the #define or use the #undef control statement.
2004	Define symbol not defined.
	The identifier specified in an #undef statement has not been defined.
	Check the spelling of the identifier.
2005	Ignore RADIX.
	If an expression uses extended language syntax, the assembler ignores the radix directive.
	Delete the radix directive.
2006	Change RADIX equal 10.
	An expression using extended language syntax does not use a radix of 10.
	Use the radix directive to change the radix to 10.
2007	Line too long.
	A source statement exceeds the length limit.
	Edit the source statement so that its length is within the limit.
2008	Macro name multiple defined.
	Multiple macros share the same name.
	Change the names of the extra macros.
2009	The usage of a series of instructions may be restricted in MN1030/
	103S series
	The usage of a series of instructions may be restricted in MN1030 series. Careful operation is
	needed as some operations are not guaranteed.
	Refer to the notes, attentions or warnings written in MN1030/MN103S Series Instruction Manual
	for 32-bit and ensure that the expected operation is guaranteed. If it is not guaranteed, modify the
	program. See Chapter 3, "How to Use Instructions" in the Instruction Manual 3rd version (or later)
	or "Chapter 5 section 2, "Programming Notes" in the former versions.
2010	The usage of this instruction may be restricted in MN1030/103S
	series.
	The usage of a series of instructions may be restricted in MN1030 series hardware. Careful
	operation is needed as some operations are not guaranteed.
	Refer to the notes, attentions or warnings written in MN1030/MN103S Series Instruction Manual
	for 32-bit and ensure that the expected operation is guaranteed. If it is not guaranteed, modify the
	program. See Chapter 3, "How to Use Instructions" in the Instruction Manual 3rd version (or later)
	or "Chapter 5 section 2, "Programming Notes" in the former versions.

252 Assembler Errors