Panasonic PT-RW330U, PT-RZ370U [SCHEDULE], Setting [ECO LEVEL DISPLAY], Enabling/disabling the schedule function, How to assign a program, Note, [ON], Note, [ON], Note, [ECO], Press, [OFF]

Chapter 4 Settings — [PROJECTOR SETUP] menu

4)Press qw to switch [STANDBY MODE].

ff The items will switch each time you press the button.

[ECO]	Use this setting to reduce power consumption during standby.
[NORMAL]	Use this setting to use the network function during standby.

Note

ff When set to [ECO], network functions are not available during standby. Also, some RS-232C commands are not available. When set to [NORMAL], network functions are available during standby.

ff If set to [ECO], there may be a delay in displaying when the power is turned on compared to when set to [NORMAL].

Setting [ECO LEVEL DISPLAY]

Display the power save level by the settings of [LIGHT POWER] and [AUTO POWER SAVE] as an illustration at the left bottom of the projection screen.

The more the number of green Leaf mark (), the more the power of the projector is saved. Screen display example:

(&2/(9(/

1)Press as to select [ECO MANAGEMENT].

2)Press the <ENTER> button.

ff The [ECO MANAGEMENT] screen is displayed.

3)Press as to select [ECO LEVEL DISPLAY].4)Press qw to switch [ECO LEVEL DISPLAY].

ff The items will switch each time you press the button.

[OFF]	Disables the ECO level display.
[ON]	Enables the ECO level display.

Note

ff If a closed caption signal of the selected mode is input, the ECO level is not displayed. ff The ECO level is not displayed when the menu screen is displayed.

[SCHEDULE]

Set the command execution schedule for each day of the week.

Enabling/disabling the schedule function

1)Press as to select [SCHEDULE].2)Press qw to switch [SCHEDULE].

ff The items will switch each time you press the button.

	[OFF]	Disables the schedule function.
	[ON]	Enables the schedule function. Refer to “How to assign a program” (x page 72) or “How to set a
	[ON]	program” (x page 73) for how to set the schedule.
		program” (x page 73) for how to set the schedule.

Note

ff When [SCHEDULE] is set to [ON], the [STANDBY MODE] setting is forcibly switched to [NORMAL], and the setting cannot be changed. Even if [SCHEDULE] is then set to [OFF] when in this state, the setting of [STANDBY MODE] remains at [NORMAL].

How to assign a program

1)Press as to select [SCHEDULE].

2)Press qw to select [ON], and press the <ENTER> button.

ff The [SCHEDULE] screen is displayed.

72 - ENGLISH