Chapter 3 Basic
Indicator status |
| Status |
Off |
| The main power is switched off. |
|
|
|
|
| The power is switched off (in standby mode). [STANDBY MODE] is set to [NORMAL]. |
| Flashing | Projection will start when the power <v/b> button is pressed. |
| ff The projector may not operate when the temperature indicator <TEMP> is flashing. | |
Red |
| (x page 109) |
| The power is switched off (in standby mode). [STANDBY MODE] is set to [ECO]. | |
|
| |
| Lit | Projection will start when the power <v/b> button is pressed. |
| ff The projector may not operate when the temperature indicator <TEMP> is flashing. | |
|
| |
|
| (x page 109) |
Green | Lit | Projecting. |
|
|
|
Note
ff The projector consumes power even in standby mode (the power indicator <ON (G)/STANDBY (R)> lights/flashes in red). Refer to “Power consumption” (x page 123) for the power consumption.
ff The power indicator <ON (G)/STANDBY (R)> flashes in green if a remote control signal is received.
ff The power indicator <ON (G)/STANDBY (R)> flashes in green slowly when the projector is in AV mute mode.
Switching on the projector
3)
3)
1)2)1)Connect the power plug to an outlet.ff (AC 100 V - 240 V 50 Hz/60 Hz)
2)Press the <ON> side of the <MAIN POWER> switch to turn on the power.ff The power indicator <ON (G)/STANDBY (R)> lights/flashes in red, and the projector enters the standby mode.
3)Press the power <v/b> button.ff The power indicator <ON (G)/STANDBY (R)> lights in green and the image is soon projected on the screen.
Note
ff If the projector is switched on at around 0 °C (32 °F), a
The temperature indicator <TEMP> lights during the
ff If the operating environment temperature is low and
ff If the [PROJECTOR SETUP] menu → [ECO MANAGEMENT] → [STANDBY MODE] (x page 71) is set to [ECO], there may be a delay in displaying when the power is turned on compared to when the setting is [NORMAL].
ff When the power is turned or an input signal is switched, you may here a
ff If the [PROJECTOR SETUP] menu → [INITIAL STARTUP] (x page 74) is set to [LAST MEMORY] and the power is turned off by pressing the <OFF> side of the <MAIN POWER> switch or by using the breaker directly while projecting at the last time of use, the power indicator <ON (G)/STANDBY (R)> lights in green and projection starts after a while when the power is turned on by pressing the <ON> side of the <MAIN POWER> switch with the power plug connected to the outlet, or when the breaker is turned on.
ENGLISH - 33