Cisco Systems 78-6897-01 manual Configuring the Router

Configuring SVCs

If the SVC terminates on a router, however, configuration is required on the router where the SVC terminates. For your convenience, the router configuration is described in this section.

Figure3-1 shows an example network that illustrates how to set up SVCs. This example network is used throughout this section.

Figure3-1 Example Network for Configuring SVCs

Configuring the Router

Perform the following tasks on both routers that terminate the SVC:

•

•

•

•

Configure PVCs for QSAAL and ILMI signaling

Configure IP and ESI addresses and subnet masks

Determine the NSAP address

Configure a map group and map list

The following subsections describe these procedures in detail.

Tips Open two Telnet windows for both the source and destination routers.

3-2ATM Switch Router Quick Software Configuration Guide