Cisco Systems 78-6897-01 manual Configure a Map Group and Map List, Configuring the Router

Configuring the Router

Example

Switch# show interface atm 0.1

ATM0.1 is up, line protocol is up

Hardware is ATMizer BX-50

Internet address is 192.153.185.65/27

MTU 4470 bytes, BW 155520 Kbit, DLY 100 usec, rely 255/255, load 1/255 NSAP address: 47.0091810000000061E5B5C01.555555555555.00

Encapsulation ATM

Switch#

Verify

Not applicable.

Configure a Map Group and Map List

On an ATM subinterface, configure the map group and a map list.

Take these steps:

Step Command

1Router> enable Router#

2Router# configure terminal Router(config)#

3Router(config-if)# interface atm port[/slot ][.subinterface ]

multipoint

4Router(config-subif)# map-groupname

5Router(config-subif)# no shutdown

6Router(config-subif)# exit Router(config)#

Purpose

Enter privileged EXEC mode.

Enter global configuration mode.

Configure an ATM subinterface.

Enter the map group name on the ATM subinterface. The map group name is used to associate a map list to the subinterface.

Enable the interface. Enter this command even if the interface is already up. This command enables the SAR 1 process to use the newly configured parameters.

Return to global configuration mode.

Configuring SVCs, PVCs, SoftPVCs, PVPs, and VPTunnels 3-7