Cisco Systems 78-6897-01 manual Configuring Signaling on the Routers

Configuring the Router

Configuring Signaling on the Routers

Configure PVCs for QSAAL and ILMI signaling on the main ATM interfaces of both the source and destination routers that terminate the SVC.

Note On the ATM switch router, the signaling and ILMI channels are set up by default and do not require manual configuration.

Take these steps:

Step Command

1Router> enable Router#

2Router# configure terminal Router(config)#

3Router(config)# interface atm port[/slot ]

Router(config-if)#

4Router(config-if)# atm pvc number 0 5 qsaal

5Router(config-if)# atm pvc number 0 16 ilmi

6Router(config-if)# end Router#

7(No command.)

Purpose

Enter privileged EXEC mode.

Enter global configuration mode.

Enter interface configuration mode on the ATM interface.

Configure a PVC for QSAAL1 signaling.

Configure a PVC for ILMI signaling.

Return to privileged EXEC mode.

Repeat this procedure on the other router.

1 QSAAL = Q.2931 protocol over signaling ATM adaptation layer

Configuring SVCs, PVCs, SoftPVCs, PVPs, and VPTunnels 3-3