Cisco Systems 78-6897-01 manual Determining the NSAP Address

Configuring SVCs

Determining the NSAP Address

Determine the ATM network service access point (NSAP) address for both the source and destination routers. The NSAP addresses is required to complete the SVC.

Step	Command	Purpose
1	Router# show interface atm	Display the 20-byte NSAP address of the
	port[/slot ][.subinterface ]	router port on which the SVC terminates.
		Enter the address in Table3-1.
		The NSAP address does not display in
		certain modes. In this case, you must enter
		an NSAP address that meets the following
		criteria:
		• It must be unique in the network.
		• It must not be a broadcast or multicast
		MAC address.
2	(No command.)	Repeat this procedure to display the NSAP
		address of the other router.

Enter the 20-byte NSAP address of each router in the space provided below in Table3-1.

Table3-1 NSAP Addresses

Router NSAP Address

Source router1

Destination router2

1In Figure3-1, the source router is router A.

2In Figure3-1, the destination router is router D.

3-6ATM Switch Router Quick Software Configuration Guide