Cisco Systems 78-6897-01 manual Example, Verify, Configuring Soft PVCs Step Command, Purpose

Configuring Soft PVCs

Step Command

8Router(config-subif)# map-listname

9Router(config-map-list)# ip dest-addressatm-vcvcd broadcast

10Router(config-map-list)# end Router#

11(No command.)

Purpose

Create a map list. The name you enter here should match the name you specified in Step 6.

Add the destination router IP address. The VCD number must match the VCD number you assigned in Step 5.

Return to privileged EXEC mode.

Repeat this procedure on the other router.

Example

Router> enable

Router# configure terminal

Router(config)# interface atm 0.10

Router(config-subif)#ip address 192.153.185.33 255.255.255.224 (source router) Router(config-subif)#atm pvc 2 0 50 aal5snap

Router(config-subif)# map-group cal

Router(config-subif)# exit

Router(config)# map-list cal

Router(config-map-list)# ip 192.153.185.65 atm-vc 2 broadcast (destination router) Router(config-map-list)# end

Router#

Verify

Router# ping 192.153.185.65

Type escape sequence to abort.

Sending 5, 100-byte ICMP Echoes to 192.153.185.65, timeout is 2 seconds:

!!!!!

Success rate is 100 percent (5/5), round-trip min/avg/max = 1/1/1 ms

3-18ATM Switch Router Quick Software Configuration Guide