TCP/IP Configuration Chapter 6
6.3 Running Telnet
The Configuration Utility
Unit Serial no. 460121 V5.04
Main Menu
1.IP Parameters
2.LPD Printers
3.Protocols
4.Reset Unit
5.Restore Factory Defaults
6.Change Password
E.Exit
4.To end your Telnet session, type E at the Main Menu. If you have made any changes you are prompted to either Save Changes and Exit or Exit Without Saving Changes. Choose your option and press Enter .
Note
• Press ? to access the Telnet help utility.
6.3.2 Configure IP Parameters
Although the NIC must have an IP address before a Telnet Connection can be made, you can use the utility to change the address or the other IP parameters. The NIC will automatically initiate a soft reset when the IP address change is sensed.
Note
•This will cause the Telnet connection to be broken. It is advisable to make all other desired changes before changing the IP address.
1. At the Main Menu, type 1 and press Enter to bring up the IP Parameters menu (shown on the next page).
