Interface Card
Chapter 2
Installing the Network
2.3 Connecting to a Network the NIC
2.3 Connecting to a Network the NIC
Use an RJ45 connector (10/100BaseT) or BNC connector (10Base2) to connect to an Ethernet.
1.Turn off the printer.
2.Connect the connector to the NIC.
Feritecore
Tie band
10/100BaseT:
Plug an RJ45 connector into the 10/100BaseT port on the back of the NIC. Attach the ferrite core so that it is near the connector. Next, secure the ferrite core so that it cannot move out of position using the tie band.
10Base2:
Use a BNC T adapter to connect to the BNC connector on the back of the NIC.
3.After you make the connection, perform the procedure under 2.2 Powering Up the Printer.
Note
•Use a Category 5 cable when connecting with a 10/100BaseT.
•Be sure to use a cable with a ferrite core when making a 10/ 100BaseT connection.
