5.3 Configuring the NIC

5.3.3 Protocol Setup

Use the Protocol Setup option to configure network protocols other than AppleTalk. Selecting the Protocol Setup function displays the following screen:

Note

The default values for the IP address and Subnet Mask are shown as zeros. However, this represents a “no IP address” condition, not an IP address.

1.Click the protocols to On if you want them to be active. Click those protocols that you do not want to use to Off. The utility will not let you make active any protocol that the NIC does not support or cannot handle because of active protocol limitations.

2.Type the IP address and subnet mask if you have enabled TCP/IP. Type the default gateway address, if you have one.

3.Click on OK when you have finished using this screen.

4.You must power the printer off and on to make the changes take effect.

5.3.4 Options

Click on Status Sheets: Enable to send a status report to the printer each time you power it on, or click on Disable to disable this option. Click on OK. The change takes effect the next time you power on the printer.

AppleTalk Configuration Chapter 5

5-5

Page 87
Image 87
Hitachi Koki USA DDC 35n user manual Protocol Setup, Options