Jumper Settings

The NIC will normally automatically configure the network configuration without the need to access internal jumpers. However, there are certain jumpers on the card that you may have to access under certain circumstances. If you need to change the jumpers, follow the steps in this section.

HANDLING PRECAUTIONS

FOR

STATIC SENSITIVE DEVICES

The Network Interface Card is normally contained within the printer which acts to protect sensitive components from damage due to electrostatic discharge (ESD) during normal operation. When performing installation procedures, however, take proper static control precautions to prevent damage to equipment.

Make sure you do not have the printer plugged into a wall outlet. If it is, unplug the power cord BEFORE you open the unit. Remove the NIC according to the printer instructions.

Jumper Settings Appendix A

A-1

Page 153
Image 153
Hitachi Koki USA DDC 35n user manual Jumper Settings