Chapter 4
[SYSTEM SELECTOR]
The projector will automatically detect the input signal, but you can set the system method manually when an unstable signal is input. Set the system method matching the input signal.
1)Press as to select [SYSTEM SELECTOR].2)Press the <ENTER> button.3)Press as to select a system format.ff Available system formats vary depending on the input signal.
Terminal |
| System format | |
| Select [AUTO], [NTSC], [NTSC4.43], [PAL], | ||
<VIDEO IN> terminal | Set it to [AUTO] normally. (The [AUTO] setting will automatically select [NTSC], [NTSC4.43], [PAL], | ||
| |||
| Switch the setting to the signal method for the TV used. | ||
|
|
| |
<COMPUTER IN> terminal, | 480i, 576i, or 576p signal | Select [RGB] or [YCBCR]. | |
VGA60 or 480p signal | Select [VGA60], [480p], or [480pRGB]. | ||
Other movie based signals | Select [RGB] or [YPBPR]. | ||
| |||
480p or 576p signal | Select [RGB], [YCBCR444], or [YCBCR422]. | ||
Other movie based signals | Select [RGB], [YPBPR444], or [YPBPR422]. | ||
| |||
<HDMI IN> terminal | 480p or 576p signal | Select [AUTO], [RGB], [YCBCR444], or [YCBCR422]. | |
Other movie based signals | Select [AUTO], [RGB], [YPBPR444], or [YPBPR422]. | ||
|
*1 When
ff Refer to “List of compatible signals” (x page 121) for compatible signals.
ff This may not function properly for some external devices that are connected.
sRGB-compliant video
sRGB is an international standard
Set the projector using the following procedures for more accurate color reproduction that complies with sRGB.
1)Set [COLOR MATCHING] adjustments to [OFF].ff Refer to [COLOR MATCHING] (x page 59).
2)Display the [PICTURE] menu.ff Refer to “[PICTURE] menu” (x page 46).
3)Press as to select [PICTURE MODE].4)Press qw to set [NATURAL].5)Press as to select [COLOR].6)Press the <DEFAULT> button on the remote control to set factory default settings.
7)Follow Steps 5) to 6) to set factory default settings for [TINT] and [COLOR TEMPERATURE]. Note
ff sRGB is available for RGB signal input only.
50 - ENGLISH