Chapter 4
[COOLING CONDITION]
Change the fan control depending on the direction of projection.
Set [COOLING CONDITION] correctly in accordance with the direction of projection referencing the following figure. Using the light source with incorrect settings may shorten its life.
>9(57,&$/ 836(77,1*@
>)/2256(77,1*@ | | >&(,/,1*6(77,1*@ |
| |
|
>9(57,&$/ '2:16(77,1*@
:3URMHFWLRQGLUHFWLRQ
1)Press as to select [COOLING CONDITION].2)Press the <ENTER> button.
ff The [COOLING CONDITION] screen is displayed.
3)Press as to select a cooling condition.4)Press the <ENTER> button.
5)When the confirmation is displayed, select [OK] or [CANCEL], and press the <ENTER> button.
[ECO MANAGEMENT]
A function that optimizes the light source power to suit usage conditions to reduce power consumption.
Setting [LIGHT POWER]
1)Press as to select [ECO MANAGEMENT].2)Press the <ENTER> button.
ff The [ECO MANAGEMENT] screen is displayed.
3)Press as to select [LIGHT POWER].4)Press qw to switch [LIGHT POWER].ff The items will switch each time you press the button.
[NORMAL] | Set when high luminance is required. | |
[ECO SAVE1] | Reduces average power by approximately 20 % compared to [NORMAL] without affecting the | |
brightness. | ||
| ||
[ECO SAVE2] | Reduces average power by approximately 30 % compared to [NORMAL] without affecting the | |
brightness. | ||
| ||
[LOW] | Set when high luminance is not required and you want to save more power. |
Note
ff The rate of reduction of power consumption when the eco save mode is set refers to the ratio of average power consumption when projecting a “Broadcast” video signal that complies with IEC62087.
ff When [ECO SAVE1] and [ECO SAVE2] is set, the image may appear differently to [NORMAL].
ff If you feel that the brightness has decreased with [ECO SAVE2], switching to [ECO SAVE1] may improve the image. ff When [LOW] is set, the operating noise can be reduced.
ff When the VIDEO input is selected, [ECO SAVE1] and [ECO SAVE2] cannot be selected. When [ECO SAVE1] or [ECO SAVE2] is set while selecting other than VIDEO input, and when the VIDEO input is selected, [LOW] is set.
ff When [PICTURE MODE] is [NATURAL] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may not conform to sRGB standards.
ff When [PICTURE MODE] is [REC709] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may not conform to REC709 standards.
ff When [PICTURE MODE] is [DICOM SIM.] and [ECO SAVE1] or [ECO SAVE2] is selected, the projected image may be displayed different from DICOM standards.
70 - ENGLISH