Chapter 4
Note
ff When [ASPECT] is set to [NATIVE], [ZOOM] cannot be adjusted.
When [ASPECT] is set to [NORMAL]
1)Press as to select [ZOOM].
2)Press the <ENTER> button.
ff The [ZOOM] screen is displayed.
3)Press as to select [MODE].4)Press qw to switch [MODE].[INTERNAL] | Enlarges the size within the aspect range set with [SCREEN FORMAT]. |
[FULL] | Enlarges the size to the entire display area set with [SCREEN FORMAT]. |
[OFF] | Set the [VERTICAL] and [HORIZONTAL] zoom ratio. |
[ON] | Use [BOTH] to set zoom ratio. Horizontal and vertical can be expanded by units of 1.0 time. |
ff If [ON] is selected, select [BOTH].
8)Press qw to adjust.Note
ff When [ASPECT] is set to other than [NORMAL], [MODE] is not displayed.
[CLOCK PHASE]
You can adjust to achieve an optimal image when there is a flickering image or smeared outlines.
1)Press as to select [CLOCK PHASE].2)Press qw or the <ENTER> button.
ff The [CLOCK PHASE] individual adjustment screen is displayed.
3)Press qw to adjust.ff Adjustment value will change between [0] and [31]. Adjust so that the amount of interference is at a minimum.
Note
ff Optimal value may not be achieved if the output from the input computer is unstable. ff Optimal value may not be achieved when there is a shift in the total dot numbers.
ff [CLOCK PHASE] can be adjusted only when an analog RGB signal is input to the <COMPUTER IN> terminal or the
ff If you press w while the adjustment value is [31], the value will become [0]. If you press q while the adjustment value is [0], the value will become [31].
ENGLISH - 53