Panasonic PV-DV202 Camera Recording, Simple Recording, To conserve power, Evf

Set to REC-SPEED “SP” or “LP” in the CAMERA Mode Menu.

(Menu OSD: p. 108)

Set POWER to CAMERA.

Camera Recording

Simple Recording

Remove the lens cap and clip it to the hand strap.

Clip here

EVF

REC/PAUSE mode

POWER Lamp

1, 5

POWER

2Vision Adjustment Control

3MENU

4REC/PAUSE

Before you begin

•Connect the Palmcorder to a power source. (pp. 14, 15)

•Insert a cassette with the record tab closed. (p. 7)

1

•The POWER Lamp lights red.

•Be sure POWER is fully turned to the CAMERA position.

2 With the Viewfinder Eye Cup held up against your eye, adjust the Vision Adjustment Control to your eyesight.

• Adjust the EVF Brightness of the Viewfinder if necessary.

Please refer to “To adjust the LCD/ EVF BRIGHTNESS or COLOR” on page 19.

3

4 Press REC/PAUSE to start recording.

•“REC” is displayed on the screen. Press REC/PAUSE again to pause recording.

5 Set POWER to OFF when finished.

• To remove the cassette, slide TAPE EJECT.

• When the Palmcorder is aimed at excessively bright objects, or bright lights, a vertical bar may appear in the picture. This is a normal characteristic of the CCD pick-up device. Try to avoid this whenever possible.

WARNING:

•Do not leave the Palmcorder with the EVF aimed directly at the sun as this may cause damage to the internal parts of the EVF.

•Do not lift, or carry, the Palmcorder by the EVF or the LCD Monitor.

To conserve power

After 5 minutes, the Record/Pause mode will automatically change to Standby mode.

To resume recording, set POWER to OFF and then ON again.

18
	Forassistance, pleasecall: 1-800-211-PANA(7262)orsende-mailto:consumerproducts@panasonic.com