Panasonic PV-DV202 operating instructions Copying from Digital Equipment dubbing, Pause

Editing Features

Copying from Digital

Equipment (dubbing)

High quality digital-to-digital copying can be accomplished if both Palmcorders incorporate the DV Input/Output (i.LINK) Connector (DV interface cable (i.LINK) is not supplied).

Source (Playing)

Palmcorder

Before you begin

•Connect both Palmcorders to their power sources.

•Connect the two Palmcorders using the DV interface cable (i.LINK)

(4-pin to 4-pin).

•Turn both Palmcorders ON.

1 Insert a pre-recorded tape into the

source (playing) Palmcorder, and set

POWER to VCR.

DV Input/Output	2 Insert a blank tape with the record
	tab closed into the target (recording)
(i.LINK) Connector	Palmcorder and set POWER to VCR.

DV Interface Cable (i.LINK) (optional)

3, 4, 5

PAUSE

4REC

3, 4, 5

PAUSE

6STOP

Recording	3 Press	(PLAY) on the source
Palmcorder	Palmcorder. When the tape reaches
	the point you want to start dubbing,
	press	(PAUSE).
	4 Hold down REC and press (PLAY)
	on the target (recording) Palmcorder or
	on the remote control.
	Press	(PAUSE) to pause the tape at
	the starting point of the dub.
3, 4PLAY	5 Simultaneously, press (PAUSE) on
	both units to begin dubbing.
	6 Press	(STOP) on the recording
	unit, and then press (STOP) on the
6STOP	playing unit to end dubbing.
	Note
	• When two Palmcorders are used for
	dubbing, it is recommended that the
	Remote Control VCR1 or VCR2 setting be
	used to avoid improper-operation.
	• When two Palmcorders are connected
	using the DV interface cable (i.LINK) (not
	supplied), a Video Editing Controller
	cannot be used.
4REC	• Do not connect both an S-Video Cable or
	A/V Cable and a DV Interface Cable
	(i.LINK).
3, 4	CAUTION:
PLAY	Unauthorized exchanging and/or

copying of copyrighted recordings may be copyright infringement.

Editing Features

47