User management
71
The following procedure is to register information for PCs (hosts) that can access the camera over a network.
Up to 32 hosts can be registered.
1Click the [User mng.] button on the setup menu.
2On the sub-menu that appears, click [Host].
This will display the "Host setting" window.
3Configure the settings for each item.
Refer to “Host settings” table for details about the settings.
4Click the [Set] button.
Host settings
♦Initial default
Note:
• Clicking the [Registration] button does not log out other users.
Hosts
Item Settings Description
Host IP address Address input (Blank♦) Enter the IP address.
• Enter single-byte numerals in the range of 0 to 255.
• You can use the "*" special character to represent any
number.
• "0.0.0.0" or "*.*.*.*" cannot be registered.
Level LV1♦ / LV2 / LV3 / LV4 Specifies the user level.
• For operations that can be performed at each level, refer to
"User level (page 73)".
Access priority 1♦ to 16 Specifies the priority sequence for operations when multiple
users are logged in on the recorder at the same time.
Default screen [Cam.1]♦ to [Cam.64] / [Cam.1-4]
/ [Cam.5-8] / to / [Cam.61-64] /
[Seq]
Specifies the live image display immediately after log in.
• Selecting [Cam.1] to [Cam.64] displays the images of the
selected cameras on a 1-image screen.
• Selecting [Cam.1-4] to [Cam.61-64] displays the live images
of the selected cameras on a 4-image screen.
• Selecting [Seq] displays images in a specified sequence.
Camera partitioning [View/Operate]♦ / [View] / [--] Specifies the scope of control for each camera channel.
• When [View/Operate] is selected, live/recorded image
display or camera operation can be performed.
• When [View] is selected, live/recorded image display can be
performed, but camera operation cannot.
• When [--] is selected, neither live/recorded image display nor
camera operation can be performed.
Important:
• You must click press the [Set] button to activate settings on the recorder when registering, editing, or deleting hosts.