Network
66
Use the following procedure to configure settings for sending a message to a preset address whenever an event or error occurs.
Up to four destinations can be specified.
Special separately available software* must be installed on the PC receiving the notification in order to display the received event or error
information.
* Refer to the "readme.txt" file on the CD-ROM for details about the software.
1Click the [Network] button on the setup menu.
2On the sub-menu that appears, click [Panasonic alarm
protocol].
This will display the "Panasonic Alarm Protocol Settings"
window.
3Configure the settings for each item.
Refer to “Panasonic alarm protocol settings” table for details
about the settings.
4Click the [Set] button.
Panasonic alarm protocol settings
♦Initial default
Panasonic alarm protocol
Item Settings Description
Port number (to PC) Port number input (1818♦) Enter the port number to be used for Panasonic alarm protocol.
Retry 1 to 30 (2♦) Specifies the number of retries when sending to the PC is
unsuccessful.
Destination address
Address1 to 4 Address input
(Blank♦)
Specifies the address of the Panasonic alarm protocol
destination PC. Enter an IP address or host name for
addresses 1 through 4.
• Enter up to 255 single-byte alphanumeric characters,
including hyphen (-) and period (.).
• When entering a host name, you must use the DNS.