47
Transmitting data
You can transmit camera images to the FTP server. You can either
use image transmission by periodic timer [Image transmission by
periodic timer] to transmit images periodically to the FTP server or
an alarm [Image transmission by alarm] to send camera images to
the FTP server during an event.
It is necessary to perform the settings on the setup menu to transmit
images from cameras to an FTP server periodically.
Set the directory on the destination server, the transmission interval,
and the camera channel to transmit images from under [Server] on
the setup menu. Also, configure image transmission by periodic
timer settings under [Image transmission by periodic timer] on the
setup menu. Refer to the Setup Instructions (PDF file) for
information about settings.
Image transmission by periodic timer cannot be used when the
image compression format of the camera channel set in [Image
transmission by periodic timer] is [MPEG-4].
You must configure settings for sending camera images to the FTP
server when an event occurs in advance on the setup menu.
Configure the settings for the destination server name, and the
transmit time of pre-event and post-event images under [Image
transmission by alarm] on the setup menu. Also, configure image
transmission by alarm settings under [FTP image transmission by
alarm] on the setup menu. Refer to the Setup Instructions (PDF file)
for information about settings.
Alarm mail (notification of the time and date of an event) is sent to
registered e-mail addresses when an event occurs. You must
configure the settings on the setup menu in advance to send an
alarm mail when an event occurs (refer to the Setup Instructions
(PDF file)).
Note:
• A single image is attached to the e-mail.
• Up to 4 addresses can be registered to receive the alarm mail.