Using the Front Panel for Operations
51
11 Check the disk information.
Check the following content related to the HDD under [Disk
information] on the settings menu. Refer to the Setup
Instructions (PDF file) for more information.
• HDD capacity
• HDD remaining capacity
• Hour meter
• Disk operation mode
• Date range of video recorded on the HDD
Note:
• You cannot remove individual HDDs by opening the front panel
while operating in RAID5 or RAID6 mode.
• Refer to page 53 when replacing HDDs with errors.
Sets the HDD operation mode.
The initial setting is set to [SINGLE mode].
This setting is not necessary to use the single mode as it is set up.
1Turn off the recorder.
Turn off the power according to "Turning Off the Power
(page 39)".
2Turn on any extension units first if any are connected.
3Insert the key (included) into the key hole and turn it
while pressing in gently to open the front cover.
4Sets the operation mode with the [RAID] switch.
5Hold down the [USE] button and turn on the power to
boot up.
• The settings are enabled at bootup. Continue to press the
[USE] button until the buzzer sounds.
Setting the HDD's Operation Mode
S : SINGLE mode (default)
R5 : RAID5 mode
R6 : RAID6 mode
Important:
• The HDD operation mode cannot be changed once the
system is operating. Recorded data may not be read correctly
if the mode is changed after the system is operating.
(1)
(2)
[USE] button [RAID] switch
ND400_Basic.book 51 ページ ２００８年７月１０日 木曜日 午前１０時５０分