Using the Front Panel for Operations
46
You can install HDDs from the recorder while it is in operation.
1Insert the key (included) into the key hole and turn it to
the right while pressing gently to open the front cover.
2Insert the HDD units into the HDD bay slots while
checking each HDD number marked on the HDD bay
slots.
Press the HDD unit's removal knob down and lift the lever,
and then insert it all the way into the disk slot.
(1) Hook the HDD unit's tab securely on the
HDD bay slot.
(2) Press the lever down and push the HDD
unit until the removal knob clicks.
3The HDD is automatically recognized.
•While the HDD is being recognized, the HDD status
indicator blinks orange.
Once the HDD is recognized, the HDD status indicator
lights green or blinks.
• The HDD is automatically formatted if it is not
preformatted.
The HDD status indicator lights green after formatting is
complete.
• Preformatted HDDs are recognized for playback only. In
this case, the HDD status indicator blinks green. Follow
the instructions from step 4 to use the HDD for recording.
Note:
• The HDD status indicator may light green before blinking
orange when an HDD is inserted.
4Press the [USE] button for over 2 seconds.
A buzzer sounds.
Press the front panel buttons according to the directions on
the LCD.
5Press the arrow buttons (up or down) on the front panel
until [HDD Operate] appears on the screen.
6Press the [SET] button.
7Press the arrow buttons (up or down) on the front panel
until [Link HDD] appears on the screen.
8Select [YES] with the arrow buttons (left or right) and
then press the [SET] button.
9Select the device where you installed the HDD
(Recorder: MAIN, Extension unit x: EXTx) with the arrow
buttons (up or down) and press the [SET] button.
10 Select the device where you installed the HDD with the
arrow buttons (up or down) and press the [SET] button.
Installing HDDs
(1)
(2)
(1)
(1)
(2)
ND400_Basic.book 46 ページ ２００８年７月１０日 木曜日 午前１０時５０分