-10-
Cutout in Decoration Cover
Note:Remove sharp edges to protect the cables.
b. Top Cable Exit
Prepare a hole in the ceiling board to run the
cables.
1. Mark the mounting holes on the ceiling, using the
removed camera mounting base as a template.
2. Fix the camera mounting base to the ceiling with
four screws (not provided, M4).
3. Hook the fall prevention wire on the camera mount-
ing base.
Cautions:
•Use the supplied dust protection sheet if the cam-
era mounting base is liable to be exposed to a
dusty atmosphere. Remove the cover from the dust
protection sheet, then stick the sheet on the cam-
era mounting base.
•Remove the sheet before mounting the camera on
the base.
•While the camera is separated from the base, keep
the camera in the supplied polyethylene sack.
4. Mount the camera on the camera mounting base
and rotate the camera clockwise.
Marking
Be sure to match the wire with the fall
prevention wire fixing angle as shown below.
Fall prevention
wire fixing angle
Ring of the
fall prevention
wire
15°