Parker Hannifin GEM6K manual Network Analog Output, Ano , Ntio, \Tano, \Tio

\ANO

Type:

Syntax:

Units:

Range:

Default:

Response:

See Also:

Network Analog Output

Network		Product	Rev
<!>n\mANO.i=r		6K	5.3
n =	network server #
m =	module #
i =	analog output # on module “m”
r =	voltage value (VDC)
n =	1-6
m =	0-7
i =	1-2
r =	-10.00 to +10.00
n/a
n/a

[ \ANO ], NTIO, \TANO, \TIO

Use the \ANO command to set the voltage of an OPTO22 analog output. The maximum output range can be set from –

10.00VDC to +10.00 VDC. The 6K controller does not recognize the voltage range set on the I/O device (i.e., an \ANO setting of +10 VDC is allowed for an analog output configured with a maximum limit of +5 VDC.)

The controller addresses the OPTO22 I/O locations as follows:

Each I/O bit is addressed by its location on a specific module. (NOTE: I/O points are not addressed by an absolute

32-bit location on the OPTO22.) Digital input and output modules have four I/O points, or channels, and are numbered 1-4. Analog input and output modules have two I/O points, or channels, and are numbered 1-2.

EXAMPLE: OPTO22 is Network Server #2

0	1	2	3	4	5	6	7
Digital	Digital	Digital	Digital	Analog	Analog	Analog	Analog
Input	Input	Output	Output	Output	Output	Input	Input
Module	Module	Module	Module	Module	Module	Module	Module
Input	Input	Output	Output	Output	Output	Input	Input
1	1	1	1	1	1	1	1
Input	Input	Output	Output	Output	Output	Input	Input
2	2	2	2	2	2	2	2
Input	Input	Output	Output
3	3	3	3
Input	Input	Output	Output
4	4	4	4

	2\0IN.3		2\3OUT.2		2\5ANO.1	2\7ANI.2
Example:	; Identify network server #2 as an			OPTO22 unit at IP address
2NTIP2,172,54,125,34
2NTCONN1	; 172.54.125.34
	; Attempt a	connection to network server #2 (OPTO22 unit)
2\4NTIO4	; Server #2	(OPTO22), module #4 is		an analog output module
2\5NTIO4	; Server #2	(OPTO22), module #5 is		an analog output module
2\4ANO.1=4.8	; On Server	#3, module #4, set the		voltage on analog output #1 to
	; +4.8 VDC

page 35