Parker Hannifin GEM6K manual Network Digital Output, Out , Ntio, \Tio, \Tout

\OUT

Type:

Syntax:

Units:

Range:

Default:

Response:

See Also:

Network Digital Output

Network	Product	Rev
<!>n\mOUT<b><b><b><b>	6K	5.3
<!>n\mOUT.i-b
n = network server #
m = module #
b = enable bit
i = digital output # on module “m”

n= 1-6 m = 0-7

b = 1 (turn on), 0 (turn off), or X (don’t change) i = 1-4

n\mOUT0000

n/a

[ \OUT ], NTIO, \TIO, \TOUT

Controlling Multiple Outputs

Output #1

Output #2

Output #3

Output #4

n \ m OUT b b b b

Network Server #
(Range: 1-6)	Options for “b” are:
	1 = Turn on
Module # on Server “n”	0 = Turn off
	x = Don’t Change
(Range: 0-7)

Controlling One Output

		Output Number
		(Range: 1-4)
	n \ m OUT .i - b
Network Server #		Options for “b” are:
(Range: 1-6)
		1 = Turn on
		0 = Turn off
Module # on Server “n”		x = Don’t Change
(Range: 0-7)

Use the \OUT command to control the state of each digital output on the OPTO22 unit.

The controller addresses the OPTO22 I/O locations as follows:

Each I/O bit is addressed by its location on a specific module. (NOTE: I/O points are not addressed by an absolute

32-bit location on the OPTO22.) Digital input and output modules have four I/O points, or channels, and are numbered 1-4. Analog input and output modules have two I/O points, or channels, and are numbered 1-2.

EXAMPLE: OPTO22 is Network Server #2

0	1	2	3	4	5	6	7
Digital	Digital	Digital	Digital	Analog	Analog	Analog	Analog
Input	Input	Output	Output	Output	Output	Input	Input
Module	Module	Module	Module	Module	Module	Module	Module
Input	Input	Output	Output	Output	Output	Input	Input
1	1	1	1	1	1	1	1
Input	Input	Output	Output	Output	Output	Input	Input
2	2	2	2	2	2	2	2
Input	Input	Output	Output
3	3	3	3
Input	Input	Output	Output
4	4	4	4

	2\0IN.3		2\3OUT.2	2\5ANO.1	2\7ANI.2
Example:	; Identify network server #2 as an OPTO22 unit at IP address
2NTIP2,172,54,125,34
2NTCONN1	; 172.54.125.34
	; Attempt a	connection to network server #2 (OPTO22 unit)
2\2NTIO2	; Server #2	(OPTO22), module #2 is a digital output module
2\3NTIO2	; Server #2	(OPTO22), module #3 is a digital output module
2\3OUT1001	; On Server	#2, module #3, turn on Outputs #1 and #4 and turn off
2\2OUT.3-1	; Outputs #2 and #3
	; On Server	#2, module #2, turn on only Output #1

page 38