Techno Tidbits and
Symptom | Cause | Remedy |
During playback of a 96kHz • SIGNAL SELECT is set to ANALOG source, the display doesn't
show 96kHz
•SET the SIGNAL SELECT to AUTO (see page 44).
Remote control
Cannot be remote controlled. • The remote control batteries have worn | • Replace the batteries (see page 7). |
out. |
|
• Too far away or improper angle of opera- | • Operate within 23 feet and a 30° angle |
tion. | of the remote sensor on the front panel |
• There is an obstacle between the | (see page 8). |
• Remove the obstacle or operate from | |
receiver and the remote control. | another position (see page 8). |
• Strong light such as fluorescent light is | • Avoid exposing the remote sensor on |
shining onto the unit's remote control | the front panel to direct light. |
signal |
|
• A cord is connected to the CONTROL IN | • Connect cord to the correct jack. |
terminal on this unit. |
|
• The IR Receiver type is mismatched with | • Disconnect the IR Receiver from the |
the setting. | rear panel, and set to the other IR |
| Receiver type using the remote control. |
|
|
Other components can't be operated with the system remote.
•The preset code settings are wrong.
•The batteries wore out and the system settings were cleared.
•Input the correct preset code.
•Reset the proper system settings.
The SR cable is connected, but the connected components can't be operated with the remote.
•The SR cable hasn't been connected properly.
•The rest of the component connection have not been made.
•The component you have hooked up is not SR compatible.
•Reinsert the SR cable, making sure it is the right jack (see page 74).
•Make sure an analog connection has been made between the units.
•This is not a malfunction.
Miscellaneous
There seems to be a time lag | • The subwoofer channel can be delayed | • The MCACC system will automatically |
between the speakers and the | slightly if run through a | compensate for a delay in the sub- |
output of the subwoofer. |
| woofer output during the Auto Sur- |
|
| round Sound Setup. |
|
|
|
If the unit does not operate normally due to external effects such as static electricity
Disconnect the power plug from the outlet and insert again to return to normal operating conditions.
EXPERT
103
