Basic Operation
Adjusting Bass and Treble
You can adjust the low (bass) and high (treble) frequencies. The TONE button can also be used to bypass the tone circuitry.
1 Press RECEIVER.
2 Press the TONE button on the remote control or the front panel to put the receiver in tone adjust mode.
Pressing the TONE button changes the mode to either on or off. When the mode is set to on, TONE appears in the display.
3 Press the BASS/TREBLE button repeatedly to select BASS or TREBLE.
If TONE: BYPASS appears, press the TONE button to get
TONE: on.
2 3 4 |
4Use the +/– buttons to adjust the low or high frequency levels.
A few seconds after you finish adjusting the tone the receiver will revert to the sound mode it was in at the beginning of the process.
Memo:
•The tone control can be adjusted in a range of ±6 dB.
•The tone control cannot be set on in THX CINEMA, MULTI CH IN modes.
•If you set TONE control on in DIRECT mode the receiver will switch to STEREO mode.
Listening with Sound Delay
Some video displays have a slight delay in presentation of the video. Using sound delay you can slow the presentation of the sound to match the presentation of the video.
1 Press RECEIVER.
2 Press the EFFECT/CH SEL button repeatedly until you see DELAY in the receiver’s display.
3 Use the +/– buttons to add or subtract the amount of delay.
Memo:
• The amount of delay changes in 0.1 frame steps from 0.0 – 6.0 frame. (The default setting value is 0.0 frame.)
• When in DIRECT or MULTI CH IN modes, sound delay cannot be used.
BASIC
51
