| Displays and Controls |
BASS/TREBLE buttons (see page 51) | 9 MULTI OPERATION button |
Use to select whether the bass or treble will be | Use this button with MULTI OPERATION |
adjusted. | (page 75) and SYSTEM OFF (page 77). |
(+/–) buttons
Use to adjust the TONE level, effect level, channel level and sound delay as well as make Dolby Pro Logic II MUSIC parameter settings.
EFFECT/CH SEL button
Switches between the different channels so you can add volume individually to each channel with the + and – buttons. Also selects EFFECT mode, Dolby Pro Logic II MUSIC parameters (see page 48) and sound delay settings (see page 51). You can then use the + and – buttons to make these adjustments.
SIGNAL SEL button (see page 44)
Press repeatedly to select one of the following: AUTO – If there are analog and digital signals input, the receiver automatically selects the dig- ital signal.
DIGITAL – To select an optical or coaxial digital signal.
ANALOG – To select an analog signal.
DNR (DIGITAL NR) button (see page 49)
Switches the DIGITAL NR on or off.
VIDEO SEL button (see page 56)
Use to toggle between the different video input possibilities.
HI-BIT button (see page 52)
Use this button to switch the AUDIO SCALER on or off.
8TV CONTROL buttons
The following buttons are used to control the TV only and can be used once they are preset to control your TV.
TV button
This is a dedicated TV button. Use it to turn on/ off your TV.
INPUT SELECT: Press to select the input source for the TV.
CHANNEL
VOLUME
10 LED display
This display flashes when a command is sent from the remote control to the receiver. It also flashes at other times, for example when teaching the receiver preset codes.
11 SOURCE button
Use this button to turn on/off other components. You must input the preset code in order to use this function (see page 62).
12 RECEIVER button
Use this button to switch the remote control into receiver mode in order to get certain receiver functions or do receiver setups.
13 Receiver functions
ACOUSTIC EQ button (see page 89)
Press to switch on/off and select the type of acoustic calibration EQ.
INPUT button
Press to select an input source. The button will cycle through all the possible sources.
SB CH MODE button (see page 54)
Use this button to turn the surround back channels ON/OFF/AUTO or switch the virtual surround back mode between ON/OFF/AUTO.
MULTI CH INPUT button (see page 53)
Use this button to select the component you have hooked up to the MULTI CH IN terminals (for example, a
MIDNIGHT button (see page 50)
Switches the MIDNIGHT listening mode on or off.
MUTE button
Press to mute or restore the volume.
PREPARATION
31
