Pitney Bowes LPS-1 manual Button descriptions, LED Lamp

GETTING STARTED

Button descriptions

The functions of the buttons on the LPS-1 are described below.

Button

Condition

ON/OFF button	Turns power to the LPS-1 on and off.
	• When using LA Die-cut Labels, feeds the LA Label Roll to the beginning
	of the first label on the roll. If this button is held for more than one
	second, the LA Label Roll is fed to the beginning of the next label on the
FEED button	roll.
	• When using LA Continuous Tapes, feeds 1" (25.4 mm) of the LA Label
	Roll.
	• If there is no LA Label Roll installed, the mode changes to a cleaning
	mode and the roller rotates for 1/3" (8 mm). If this button is held for more
	than one second, the roller rotates for 4" (100 mm).

LED Lamp

LED lamp on the LPS-1 indicates the current operating condition.

Lamp

Condition

Not lit	Power is OFF.
Lit	Power is ON.
	(Normally lit while power is on, the LED flashes during cleaning or if an
	error has occurred.)
	Indicates one of the following errors.
	•	Cutter error
Flashing fast	•	Label sensor error
		(LA Roll not installed correctly, end of LA Roll, or label jam)
	• LA Roll compartment cover is open during operation

•Incorrect LA Roll installed

•No LA Roll installed

Flashing slow	Cooling
	(Waiting for temperature of print head to lower)
Turns off after flashing	System error
fast ten times	Turn the LPS-1 off and then on again.
	If this error re-occurs, please contact Pitney Bowes Service Express at 1-
	800-522-0020.

6

LPS-1 Components