Ensure that the site selected for the LF 6600 Tower or Rack Mount configuration is able to support a volumetric air flow of 3.2 m3/min. (112 cfm). For the Rack Mount configuration, the back door of the enclosing equipment cabinet must have air vents. Ensure that the operating environment is free from dust.
WARNING
To prevent fire or shock hazard, do not expose the LF 6600 to rain or moisture. Refer servicing to qualified technicians.
In case of fire or other emergency, isolate the units from the main power by disconnecting the power plugs from their site power receptacles. In situations where disconnecting the plugs is not possible or practical, disconnect the system main power to isolate the units from the main power.Use of controls or adjustments, or performance of procedures other than those specified herein may result in exposure to hazardous laser radiation.
Do not stare directly into the laser beam or its reflection on any reflecting
TOWER INSTALLATION
The LF 6600 Tower configuration is shipped as a complete assembly, ready for cable connections and power up. No tools are required for the installation.
CAUTION
Remove the foam shipping block from the shuttle assembly before powering on the LF 6600.
To install the Tower configuration:
1)Connect the AC power cord as explained in the Connecting the Power Cord section. (Refer to the Installation and
2)Connect the host interface SCSI cables and appropriate signal terminators, if required, as explained in the Installation and
PLASMON LASER MAGNETIC STORAGE - LF 6600 User Manual Page 34
