REMOVING THE BEZEL
NOTE
A T15 screwdriver is required for removing the bezel assembly.
1)Release the electrical safety door lock by inserting the flat handle end of the manual release tool through the slot in the bezel and move the locking lever to the left out of the door lock tab as shown below.
RETRACT LOCK
MECHANISM BY
PULLING BACK HERE
DOOR LOCK MECHANISM
DISENGAGED
DOOR LOCK MECHANISM
ENGAGED
EP006037
Manually Overriding the Door Lock
2)Open the media access door and remove the M4 x 20 mounting screw. Unplug the door safety switch cables at the chassis and remove the bezel assembly by pulling it up and away from the lower mounting tabs on the chassis as shown in the figure below.
CAUTION
Ensure that you do not damage the door safety switch cables when you are removing the bezel.
97653976 F Page 93
