Plasmon LF6600 user manual SET the Internal Drive Serial Number SET Serial #

A

PRESS BOTH SWITCHES SIMULTANEOUSLY TO RETURN TO MAIN MENU

"Set Config"

	SELECT	Display RTPM
View RTPM		Information

MENU
SELECT	RTPM	Y	Confirm Clear
	True
	N		SELECT
Clear RTPM	No RTPM Err
	RTPM Condition is Cleared
MENU

Init DPC

SELECT Init Done Reset Drive

Self Test

MENU

Diagnostic Menu (Part 2)

SET THE INTERNAL DRIVE SERIAL NUMBER ("SET SERIAL #")

To enter the serial number submenu, press the TEST/SELECT switch while "Set Serial #" is displayed in the Main menu. The drive will enter the menu allowing the operator to view and change the internal drive serial number.

NOTE

The serial number set in the drive must correspond to the last 5 digits of the drive's actual serial number for accurate internal event logging to occur. The drive's actual serial number is located on the back of the drive enclosure.

To change the drive's 5-digit serial number, follow these steps:

1)Enter the Configuration mode by simultaneously pressing the LOAD/MENU and TEST/ SELECT switches.

2)Press the MENU switch until "Set Serial #" is displayed.

3)Press the SELECT switch to enter the serial number mode. The serial number will be displayed.

97653976 F Page 81