POWER-ON PROCEDURE

The LF 6600 is powered on with the AC Power Switch located on the rear panel. The ON position is indicated by a ( I ) and the OFF position is indicated by a ( O ) as illustrated below.

NOTE

After you turn the drive's power off, wait 1 sec before turning the power on again.

AC POWER OFF (O)

AC POWER ON (I)

EP006036

LF 6600 AC Power Switch Positions

Perform the following procedure to power on the LF 6600:

1)Ensure that the LF 6600 is properly connected (see SCSI Bus Considerations sections).

2)Refer to the Media Insertion and Removal section and insert a cartridge into slot 1. If slot 1 is empty, the LF 6600 will display "1 Empty" on the DOC shortly after initial power on.

NOTE

Slot 1 is the factory setting for the media autoload configuration option.

If this option has been changed by the user, all references to slot 1 in this manual apply instead to the slot number selected in the autoload configuration option.

Refer to the Configuration Mode section for more information on setting configuration options.

97653976 F Page 59

Page 59
Image 59
Plasmon LF6600 user manual POWER-ON Procedure