Polaroid 215EPolaview manual Disabling the Power button on the remote control unit

Getting started

Turning off the input The function which displays the currently selected input signal on the screen can be

signal display turned off by the following procedure. The procedure and on-screen displays shown below assume that an RGB signal is being used as the input signal.

	MENU		SET UP PROJECTOR
RGB ADJUST		FRONT/REAR			FRONT
RGB SYNC MENU		>INPUT DISP			ON
>SET UP PROJECTOR		REMOTE POWER			ON
LANGUAGE		EXPANSION (VGA)			ON
	/SPRACHE /LANGUE	LAMP TIME RESET			NO
	/IDIOMA /LINGUA
SELECT : PUSH ZorX		SELECT : PUSH ZorX
SET	: PUSH CorV	SET		: PUSH CorV
END	: PUSH MENU	END		: PUSH MENU

1.Press MENU to display the menu.

2.Press Z or X to select SET UP PROJECTOR, and then press C or V to display the screen.

Disabling the POWER button on the remote control unit

3.Press Z or X to select INPUT DISP, and then press C or V to select ON or OFF.

Select OFF to turn off the input signal display function.

Select ON to turn on the input signal display function. The input signal will be displayed each time it is changed. (This is the factory setting.)

4.Press MENU twice to exit.

In order to prevent the power from being turned off by mistake, the POWER button on the remote control unit can be disabled by the following procedure. The procedure and on-screen displays shown below assume that an RGB signal is being used as the input signal.

	MENU		SET UP PROJECTOR
RGB ADJUST		FRONT/REAR			FRONT
RGB SYNC MENU		INPUT DISP			ON
>SET UP PROJECTOR		>REMOTE POWER			ON
LANGUAGE		EXPANSION (VGA)			ON
	/SPRACHE /LANGUE	LAMP TIME RESET			NO
	/IDIOMA /LINGUA
SELECT : PUSH ZorX		SELECT : PUSH ZorX
SET	: PUSH CorV	SET		: PUSH CorV
END	: PUSH MENU	END		: PUSH MENU

1.Press MENU to display the menu.

2.Press Z or X to select SET UP PROJECTOR, and then press C or V to display the screen.

3.Press Z or X to select REMOTE POWER, and then press C or V to select ON or OFF.

Select OFF to disable the POWER button on the remote control unit.

Select ON to use the POWER button on the remote control unit normally. (This is the factory setting.)

4.Press MENU twice to exit.

36Polaview 215E LCD Projector User’s Guide