Chapter 16-Network Services
Polycom, Inc. 16-57
—Modify the Management Network parameters on the USB Key. For more details see
the RMX™ 1800 Getting Started Guide, "Modifying the Factory Default Management
Network Settings on the USB Key” on page2-6.
2Hardware Installation and Setup
—Mount the Collaboration Server in a rack. For more details see the RMX™ 1800
Getting Started Guide Getting Started Guide, "Hardware Installation and Setup” on
page 2-6.
—Connect the necessary cables. For details, see RMX™ 1800 Getting Started Guide
Getting Started Guide, "Hardware Installation and Setup” on page 2-6.
3First Entry Power-up and Configuration
—Power up the Collaboration Server. For more details see the RMX™ 1800 Getting
Started Guide Getting Started Guide, "Procedure 1: First-time Power-up” on page2-27.
—Register the Collaboration Server. For more details see the RMX™ 1800 Getting
Started Guide Getting Started Guide, "Procedure 2: Product Registration” on page2-28.
—Connect to the Collaboration Server. For more details see the RMX™ 1800 Getting
Started Guide Getting Started Guide, "Procedure 3: Connection to MCU” on page2-29.
—Configure the Default IP Network Service using the information for one of the
networks connected a media card installed in the system. For more details see the
RMX™ 1800 Getting Started Guide Getting Started Guide, "Procedure 4: Modifying the
Default IP Service and ISDN/PSTN Network Service Settings” on page2-31.
—Optional. Configure the ISDN/PSTN Network Service. For more details see the
RMX™ 1800 Getting Started Guide Getting Started Guide, "ISDN/PSTN Services” on
page 2-4.
4Modify the required System Flag to enable Multiple Services and reset the MCU.
5Add the required IP Network Services to accommodate the networks connected to the
Collaboration Server.
6Select a Network Service to act as default for dial out and gateway calls for which the
Network Service was not selected.
7Place several calls and run conferences to ensure that the system is configured
correctly."Gather Network Equipment and Address Information - IP Network Services
Required Information” on page16-40.
Upgrading to Multiple Services
1Gather Network Equipment and Address Information for each of the networks that will
be connected to the Collaboration Server unit. For a list of required address, see RMX™
1800 Getting Started Guide, "Gather Network Equipment and Address Information” on
page2-2.
2Upgrade to the new version and install the activation key that contains the Multiple
Services license as described in the RealPresence Collaboration Server (RMX) 1500/2000/
4000 Release Notes
3Place several calls and run conferences to ensure that the system upgrade was
completed successfully.
4Modify the required System Flag to enable Multiple Services, DO NOT reset the MCU
yet.