Polycom SIP 2.2.2 Tones tones, Dual Tone Multi-Frequency Dtmf Chord-Sets chord, OnIntensity value

Administrator’s Guide SoundPoint IP / SoundStation IP

	Permitted
Attribute	Values	Default	Interpretation
up.welcomeSoundOnWarmBootE	0, 1	0	If set to 1, play welcome sound effect on warm
nabled			as well as cold boots, otherwise only a cold
			boot will trigger the welcome sound effect.
up.localClockEnabled	0, 1	1	If set to 1, display the date and time on the idle
			display
up.backlight.onIntensity	0 (off),	Null	This parameter controls the intensity of the
	1 (low),		LCD backlight when it turns on during normal
	2 (medium), 3		use of the phone.
	(high)		The default value is medium.
up.backlight.idleIntensity	0 (off),	Null	This parameter controls the intensity of the
	1 (low),		LCD backlight when the phone is idle.
	2 (medium), 3		The default value is low.
	(high)
			Note: If idleIntensity is set higher than
			onIntensity, it will be replaced with the
			onIntensity value.
up.idleTimeout	positive	Null	Timeout for the idle display or default call
	integer,		handling display.
	seconds		If set to 0, there is no timeout.
			If set to Null, the default timeout of 20 seconds
			is used.
			If set to value greater than 0, the timeout is for
			that number of seconds (maximum 65536).
up.mwiVisible	0 - Disabled	0	If set to 0 or Null, there is no MWI for
	1 - Enabled		registration x (SIP 2.1.0 and 2.1.1 behavior).
			If set to 1, msg.mwi.x.callBackMode is set to
			disabled. MWI notification will be displayed for
			registration x (Pre-SIP 2.1.0 behavior).

Tones <tones/>

This attribute describes configuration items for the tone resources available in the phone.

This attribute includes:

•Dual Tone Multi-Frequency <DTMF/>

•Chord-Sets <chord/>

A - 24