Polycom SIP 2.2.2 manual This flash attributes are defined as follows, Enabled

Administrator’s Guide SoundPoint IP / SoundStation IP

This flash attributes are defined as follows:

Name	Possible Values	Description
device.set	0 or 1	If set to 0, do not use any device.xxx.yyy fields to
	default = 0	set any parameters. Set this to 0 after the initial
		installation.
		If set to 1, use the device.xxx.yyy fields that have
		device.xxx.yyy.set = 1. Set this to 1 for the initial
		installation only.
device.xxx.yyy.set	0 or 1	If set to 0, do not use the device.xxx.yyy value.
	default = 0	If set to 1, use the device.xxx.yyy value.
		For example, if device.net.ipAddress.set = 1,
		then use the contents of the device.net.ipAddress
		field.
device.net.ipAddress	dotted-decimal IP address	Phone's IP address.
		Note: This field is not used when DHCP client is
		enabled.
device.net.subnetMask	dotted-decimal IP address	Phone's subnet mask.
		Note: This field is not used when DHCP client is
		enabled.
device.net.IPgateway	dotted-decimal IP address	Phone's default router / IP gateway.
		Note: This field is not used when DHCP client is
		enabled.
device.net.vlanId	Null, 0 to 4094	Phone’s 802.1Q VLAN identifier.
		Note: Null = no VLAN tagging
device.net.cdpEnabled	0 or 1	If set to 1, the phone will attempt to determine its
		VLAN ID through the CDP.
device.dhcp.enabled	0 or 1	For description, refer to DHCP or Manual TCP/IP
		Setup on page 3-2.
device.dhcp.offerTimeout	1 to 600	Number of seconds the phone waits for secondary
		DHCP Offer messages before selecting an offer.
device.dhcp.bootSrvUseOp	0 to 3	For descriptions, refer to DHCP Menu on page 3-7.
t
device.dhcp.bootSrvOpt	128 to 254 (Cannot be the
	same as VLAN ID Option)
device.dhcp.bootSrvOptTy	0 or 1
pe
device.dhcp.dhcpVlanDisc	0 to 2
UseOpt
device.dhcp.dhcpVlanDisc	128 to 254 (Cannot be the
Opt	same as Boot Server
	Option)

A - 100