Polycom SIP 3.0.2 manual This flash attributes are defined as follows, Enabled

Administrator’s Guide SoundPoint IP / SoundStation IP

Caution This feature is very powerful and should be used with caution. For example, an incorrect setting could set the IP Address of multiple phones to the same value.

Note that some parameters may be ignored, for example if DHCP is enabled it will still override the value set with device.net.ipAddress.

Individual parameters are checked to see whether they are in range, however, the interaction between parameters is not checked. If a parameter is out of range, an error message will appear in the log file and parameter will not be used.

Incorrect configuration could cause phones to get into a reboot loop. For example, server A has a configuration file that specifies that server B should be used, which has a configuration file that specifies that server A should be used.

Polycom recommends that you test the new configuration files on two phones before initializing all phones. This should detect any errors including IP address conflicts.

This flash attributes are defined as follows:

Name	Possible Values	Description
device.set	0 or 1	If set to 0, do not use any device.xxx.yyy fields to
	default = 0	set any parameters. Set this to 0 after the initial
		installation.
		If set to 1, use the device.xxx.yyy fields that have
		device.xxx.yyy.set = 1. Set this to 1 for the initial
		installation only.
device.xxx.yyy.set	0 or 1	If set to 0, do not use the device.xxx.yyy value.
	default = 0	If set to 1, use the device.xxx.yyy value.
		For example, if device.net.ipAddress.set = 1,
		then use the contents of the device.net.ipAddress
		field.
device.net.ipAddress	dotted-decimal IP address	Phone's IP address.
		Note: This field is not used when DHCP client is
		enabled.
device.net.subnetMask	dotted-decimal IP address	Phone's subnet mask.
		Note: This field is not used when DHCP client is
		enabled.
device.net.IPgateway	dotted-decimal IP address	Phone's default router / IP gateway.
		Note: This field is not used when DHCP client is
		enabled.
device.net.vlanId	Null, 0 to 4094	Phone’s 802.1Q VLAN identifier.
		Note: Null = no VLAN tagging
device.net.cdpEnabled	0 or 1	If set to 1, the phone will attempt to determine its
		VLAN ID through the CDP.
device.dhcp.enabled	0 or 1	For description, refer to DHCP or Manual TCP/IP
		Setup on page 3-2.

A - 106