Proxima ASA 4100/4200 manual Changing Batteries Cyclops Quick Remote

CHANGING BATTERIES – CYCLOPS QUICK REMOTE

The Cyclops Quick Remote uses two 357A alkaline batteries.

1Locate the battery compartment at the lower rear of the case. Press the corner down and slide it off.

2Remove the old batteries and replace them with new ones. Make sure to align the batteries in the proper orientation.

3Replace the battery cover.

Figure 5-5Installing batteries in the Cyclops Quick Remote

CLEANING AND REPLACING THE NOISE FILTER

The noise filter is found only on early models of the DP4100. Follow the instructions below to determine if your projector contains a noise filter. The DP4200 does not use a noise filter.

You should rinse off the noise filter after every 100 hours of use. If you are using the projector in dusty areas, clean it more frequently. If you are experiencing a high number of over-temperature problems, you may need to clean the filter more often.

CAUTION! Be sure to turn off the main AC power before opening the projector.

1Remove the two screws on the lower front panel and snap the front panel off (see Figure 5-1). Remove it carefully, as it is attached to the projector with a ribbon cable.

2Press in on the tabs on the upper front sides of the projector and pull up gently on the top panel to remove it. Remove it carefully, as it is attached to the projector with a ribbon cable.

5-4Chapter Five