
Using XFER32
The settings in these dialogs can be modified or customized to meet your communications requirements.
General TabThe General tab is the first tab displayed on the XFER32 Setup dialog box. Use this section to modify the PDT’s Connection, Baud Rate, Flow Control, Protocol (ACK/NAK is the only protocol used by the PT40), and Maximum Errors. Window Size and Crash Recovery are not supported by the PT40.
Figure 65. General Tab
Connection Enter the Connection port for file transfers. Select from the list of detected serial ports or modems.
Baud Rate | Select a Baud Rate for serial communications |
| from the |
| XFER32 is 19200. The default value for the |
| PT40 is 9600. |
| Note: The PT40 supports only baud rates |
| up to 38400. |
User’s Guide | 93 |