
PT40 Communication
Protocol | Select either XModem or ACK/NAK as the |
| |
| file transfer Protocol for sending and receiv- |
| ing files. |
| NOTE: The PT40 defaults to the ACK/NAK protocol unless you |
| select XModem. XFER32 defaults to the ZModem Protocol. |
| ACK/NAK and XModem protocol are the only two protocols sup- |
| ported by the PT40. |
Maximum Errors | NOTE: ZModem Protocol is NOT supported by the PT40. |
Enter the maximum number of Errors permitted before a file transfer | |
| is aborted. Range: 1 to 50. 0 specifies no limit to the number of file |
| transfer errors. |
Flow Control | Select the mechanism used to control the flow |
| |
| of data. Sender and receiver must agree on the |
| flow control method. |
| Note: RTS/CTS is the default. Use either None or RTS/CTS. |
None | XON/XOFF is not supported by the Falcon PT40. |
No flow control used. | |
XON/XOFF | NOTE: ZModem Protocol is NOT supported by the Falcon PT40. |
| This feature is only available with ZModem protocol. |
RTS/CTS
Window Size
Crash Recovery
Hardware flow control that uses Request to Send (RTS), and Clear to Send (CTS) serial port lines to communicate when to suspend and resume data transfer.
NOTE: ZModem Protocol is NOT supported by the Falcon PT40. This feature is only available with ZModem protocol.
NOTE: ZModem Protocol is NOT supported by the Falcon PT40. This feature is only available with ZModem protocol.
Select the Transfer tab to establish file transfer settings.
94 | PT Program Generator (PPG) v5.0 |