Q-See Computer Hardware manual Address Communication address of P.T.Z device ID number

Error! Use the Home tab to apply 标题 1 to the text that you want to appear here. Error! Use the Home tab to apply 标题 1 to the text that you want to appear here.

SuperDVR & H.264 Series Cards User Manual

DSCP, DH-SD, Lilian, Minking, Neon, PelcoD, PelcoP, Star, VIDO, VISCA

3.Address

Communication address of P.T.Z device (ID number)

4.7.2 Serial Ports Setup

Users should first enable the P.T.Z control function of a certain camera and select a port number in P.T.Z Protocol Setup (refer to Figure4-18),and then set corresponding parameters in the area below:

Figure4-19P.T.Z Serial Port Setup

1.Port

Users can set port number.

2.Baud Rate

Set P.T.Z device Baud Rate to match setting on camera, default value is 9600.

3.Data Bits Default value is 8.

4.Parity

Odd and even parity bit, default None.

5.Stop Bits Default value is 1.

NOTICE: Users should look at the control board of the P.T.Z device and get the Baud Rate, Protocol, and Address first, then enter the same values into the SuperDVR program.

42