Placing Originals
Placing Originals in the ADF
Settings should be made accordingly in the following situations:
❖When placing originals consisting of more than 50 pages:
p.15 “Batch”
❖When placing originals one by one: p.16 “SADF”
❖When placing originals of the same width but different sizes:
p.16 “Placing originals of mixed sizes”
A Set the document guide to the original size.
B Place the aligned originals face up
into the ADF. | 1 | |||||
| ||||||
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
ZGHS060E
❖When placing custom size originals: p.17 “Placing custom size origi- nals”
Note
❒Do not stack originals above the limit mark on the side guide of the ADF.
❒The last page should be on the bot- tom.
❒Do not place objects on the sensors or cover them with your hands, or the original size may not be detect- ed properly. Also, do not place an- ything on the exposure glass cover as this could cause a malfunction.
1.Limit mark
2.Document guide
Note
❒Straighten any curls in the orig- inals before placing them in the ADF.
❒To prevent multiple sheets from being fed at once, fan the origi- nals before placing them in the ADF.
❒Place the originals squarely.
Batch
The Batch mode enables you to copy originals of more than 50 pages as a single document, even if you place the originals into the ADF in instal- ments.
Important
❒Place special originals, such as trans- lucent paper, one by one.
1.Sensors
15