Copying
Copying from the Bypass Tray
The optional bypass tray is required to use this function.
Use the bypass tray to copy onto special paper such as OHP transparen-
2 cies, thick paper, thin paper, and copy paper that cannot be loaded in the paper trays.
Preparation
When the Duplex unit is attached, the default setting is [1 Sided→2 Sided].
Important
❒When copying from the bypass tray, select [1 Sided] for copying in
[Dup./Combine/Series] (for example [1 Sided] → [1 Sided].) You can change the initial settings. ⇒ p.109 “Duplex Mode Priority”
❒It is not possible to use inkjet pa-
per.For details about paper sizes and paper types, see ⇒ General Settings Guide, “Paper Type”.
❒Paper of 433 mm in length, or larg- er, is likely to jam, crease, or not feed in properly.
Note
❒If you use custom size copy paper or special paper, you should input its vertical and horizontal dimen- sions directly. See p.17 “Placing custom size originals”. The sizes you can input are as follows:
Metric | • Vertical: 90.0 – 305.0 mm | |
version | • Horizontal: 148.0 – 457.2 mm | |
|
|
|
Inch | • | Vertical: 3.55" – 12.00" |
version | • | Horizontal: 5.83" – 18.00" |
|
|
|
❒The machine can automatically de- tect the following sizes as standard size copy paper:
Metric | A3L, A4L, 8" ⋅ 13"L, A5L | |||||||
version |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
Inch | 11" | ⋅ | L | , 8 | 1 | /2" | ⋅ | L |
version |
| 17" |
|
| 11" , | |||
51/2" | ⋅ 81/2"L |
|
| |||||
|
|
|
|
|
|
|
|
|
❒When copying onto OHP transpar-
encies or paper heavier than 128 g/m2 (about 34 lb.), you need to specify the paper type. See p.24 “When copying onto OHP Trans- parencies or Thick Paper”.
❒The maximum number of sheets you can load at one time depends on paper type. The maximum number of sheets should not ex- ceed the upper limit.
❒Some kinds of envelopes might cause misfeed and wrinkle. If this happens, push down the fusing unit's green lever. See p.26 “When copying onto envelopes”. Also, be sure to place the front face of the envelope downward.
❒You must specify the paper size when using paper (tracing paper, etc.) of less than 59g/m2 thickness.
❒Select the paper size when making horizontal copies.
A Open the bypass tray.
22